Sharp® Z50 Cartridge

Reference Information:

Approximate Remanufacturing

OEM PN: ZT-50TDI

Time: 30 min.

OEM Yield: 4,000 (5% coverage)

Recommended Tools:

Phillips head screwdriver

Flathead (3mm) screwdriver

Figure 1

Instructions:

1. Remove the two phillips head screws from the clear plastic waste bin (Fig. 1).

2. Open the slide on the clear plastic waste bin, clean out the waste toner (Fig. 2).

Be sure to completely remove all the old toner.

3. Remove the larger white plastic toner cap (Fig. 3). Shake out the old toner. Do

not remove the developer from the magnetic roller.

4. If you are replacing the developer, proceed to step #5. If you are just replacing

toner, refill the reservoir with new toner. Replace cap and reassemble. Note:

It is not necessary to replace the developer every refill. The developer can be

replaced every 2-3 refills. Toner must mix with developer adequately so run

Figure 2

10-15 test sheets.

5. Remove the following eight screws: Three are located by the toner/developer

caps - two are on the stainless steel bar and three are on the gear end of the

cartridge. After removing these screws, remove the two gears on the gear end

of the cartridge (Fig. 4). The large gear is removed by pulling it straight off.

The smaller gear is removed by compressing together the two prongs in the

center of the gear. After these have been removed, remove the two end caps

(toner cap must be out.) Remove the steel bar.

6. Now the mag roller is exposed and may be removed by lifting one end and

Figure 3

then the other end (Fig. 5). Clean and vacuum the developer area and

reservoir. Clean mag roller with a clean cloth.

7. Refill developer reservoir by slowly distributing developer from the bottle

across the length of the reservoir to ensure even distribution.

8. Reinsert mag roller and reassemble in reverse order. Note: Do not fill toner

hopper up until the end cap is back on the cartridge.

9. Empty the contents of the toner bottle into the toner reservoir and recap.

Figure 4

10.Put the waste bin back into position and secure with two phillips head screws.

Note: It may take a few copies to get the toner mixed in with the developer.

Have your customer run 10-15 sheets with heavy fills before leaving the site.

Figure 5

© 2001 Oasis Imaging Products, Inc. Any attempt to reproduce any part of these instructions without the written consent of Oasis Imaging
Products, Inc. may result in legal action. All registered trademarks are the property of their respective owners.

Oasis Imaging Products, Inc. Technical Support: (888) 627-6555