fixyourownprinter.com
  Home    Reference    Printer Repair Kits    Cartridges    Fusers    Specials    Forums  
  Cross Reference | Error Codes | Guides | Manuals | Publications | Drivers | LinksSign In | Sign Up  

Kyocera Error Codes

A1Uninstalled waste toner conveyer
A2Fuser overheating
A3Fuser heater disconnection
A4Developer unit life-fuse error
A5Main charger Arc discharge of contact has occurred.
DEV,FTR,STR bias Short circuit of contact voltage has occurred.
A6Fuser/Toner Cartridge fan is not rotating at normal speed.
A7 Power supply fan error. Fan is not rotating at normal speed.
A8 Ozone fan error. Fan is not rotating at normal speed.
A9Multi-Purpose Pickup Roller movement error occured.
B1-B6Feed cassette bottom plate motor error.
B7Media transfer roller movement error. Transfer roller did not reach to transfer position or home position within 0.7 sec.
B8Cyan developing unit movement error. Developer unit did not reach contact position or home position within 1 sec.
B9Magenta developing unit movement error. Developer unit did not reach contact position or home position within 1 sec.
C1Duplex communication error
C2Duplex printing registration error
C3Duplexer feeding motor error
C4DF-30 IPC communication error
C5ST-30 backup RAM error
D0-D4Firmware program downloading errors
E0Engine communication error. Parity error occurs or no response comes back from engine.
E1Main motor unlocked. It is not phase-locked and is not rotating at normal speed.
E2Laser scanner motor error. The polygon motor does not deliver a synchronous output (L) within the predetermined period of time.
E3Laser beam detection error. The photo detector board does not deliver a synchronous output (L).
E4Fuser Heater Error.
E5Eraser error. The eraser current is less than 15 mA (normally 65 mA).
E6Engine ROM check sum error.
E8Fuser unit life fuse error
E9Toner motor error. The toner motor current is 120 mA or more for one second (normally 30 mA).
F0Controller system lock error. Communication is failed between the front panel and the main controller.
F1System Checksum Error. An error is detected in the controller. The Ready-symbol and ON LINE indicators go off; and ATTENTION lights. The printer does not operate when this message is displayed.
F2 RAM read/write error. Checksum is failed with the RAM on the main controller board.
F3Controller system error.
F429000 system ROM checksum error.
F529000 main RAM error.
F629000 system error


© 2012 fixyourownprinter.com