I got this samsung CLP-315, it kept jamming. Half of the page is out of the fuser unit already. I cleaned the feed roller but still the same problem. Could someone help me out. Thanks
I had the same problem with mine; you have a defective exit sensor. (Part # 0604-001393) Here's how to do it: 1) Open front cover and remove two screws above the ink cartridges; 2) Open the back cover, too; 3) Lift off the top cover; 4) Remove 4 screws near the green levers inside the back cover; 5) On top, remove 2 screws near the small white clips bearing the top rolerr; 6) Unclip and lift out the top roller; 7) You can now see the exit sensor at the opposite side of the machine to the two thick wires; 8) Draw back the spring-loaded sleeve at one end of the back roller and twist this out slightly to make more room to access the exit sensor; 9) Lift up the end of the unit the sensor is mounted on; 10) Unclip the old sensor from its holder: I cut off the locating tabs with a craft knife to release it; 11) Disconnect the sensor from the 3-pin electrical connector, making sure the connector does not spring back inside the case aperture; 12) Snap into place the new sensor; 13)Connect up the new sensor; 14) Reassemble!
Post to this thread Post a new message thread