Designjet 1050c error code
| Post to this thread Post a new message thread|
|Designjet 1050c error code by walter9999 (11/22/06 11:42 AM) reply|| + / -|
|Have not seen machine yet but here is the work order info I have received. |
Plotter stays on for a few hours before message 010030-034c095a. Customer has turned off and back on and the following error "boot failed" 1f50007 "hard disk failure. The errors listed are not in the service manual.
|Re: Designjet 1050c error code by Stephen (11/22/06 1:45 PM) reply|| + / -|
|If you get a hard disk failure, turn off the plotter and remove the hard drive, (it's on an EIO card).|
It's likely they can run fine with the drive removed.
|Re: Re: Designjet 5500 error code1f50007 by Anonymous (5/19/08 11:45 AM) reply|| + / -|
|Good evening: |
How do I find a solution to this problem .. Is it that hard drive can not work must change. Is there a solution or
|Re: by vanman (12/23/09 8:26 PM) reply|| + / -|
|I have the same exact issue on my designjet 5500ps What is the solution for error CODE 010030-034c095a, and then 1f500007 hard drive failure. Which parts had to be replaced?|
|Re: Designjet 1050c error code by dmzcompute (12/23/09 8:46 PM) reply|| + / -|
|You should start your own thread since this thread applies to the 1050C. For your model you need to get a replacement hard disk from hp or vendor that has the hard disk for your model. It comes preloaded with the software to run the plotter.|
|Re: Designjet 1050c error code by zahir virji (9/21/10 2:10 AM) reply|| + / -|
|My designjet 1050c plus, prints one page and the |
system error 070100 006703B5 appears. I have to turn off re-align
paper after that I print one page and same happens again. Any idea what could be the problem?
Post to this thread:
|© 2012 fixyourownprinter.com, All posts belong to their respective posters|