fixyourownprinter.com
  Home    Reference    Forums  
  Printer Repair | Laser | InkJet | Chat | SearchSign In | Sign Up  

HP Laserjet CP3525 Reset Instructions

Post to this thread   Post a new message thread

HP Laserjet CP3525 Reset Instructions by wolfrhk (5/17/12 12:44 PM) reply + / -
Instructions for resetting the HP Laserjet CP3525 (from the service manual):

Hard disk initialization (optional)
A hard disk initialization will erase and reformat the product's hard disk. Perform hard disk initialization
only if an error code displays on the control panel indicating a disk error. Always try initializing the hard
disk before replacing it.
1. Turn the product on.
2. As the product performs its power-on sequence, press and hold the Menu button until all three
lights on the control panel are lit.
3. Press the back arrow . The message INITIALIZE DISC displays on the control panel.
4. Press the down arrow . The product initializes the hard disk and continues its power-on sequence.

NVRAM initialization
CAUTION: Initializing NVRAM resets the serial number, the event log, the page counts, the calibration
settings, and the EIO card. Use the SERVICE menu to restore the serial number and page counts. You
also need to reconfigure any computers that print to this product to recognize the product. Initialize
NVRAM only when absolutely necessary. In most situations, use a cold reset to reset product variables
but still retain the needed values in the SERVICE menu.
NOTE: Print a configuration page before initializing NVRAM.
From the configuration page and supplies status page, gather the following information:
Total page count and color page count
Serial number
1. Turn the product on and watch the control panel display.
2. When the display shows the memory count, press and hold the down arrow until all three lights
on the control panel are lit.
3. Press the up arrow .
4. Press the Menu button. The message SKIP DISK LOAD displays on the control panel.
5. Press the up arrow until NVRAM INIT is highlighted, and then press the OK button . The product
initializes NVRAM and then continues its power-on sequence.

Product cold reset
Before beginning, print a configuration page and supplies status page. Use these pages to verify resets
have occurred.
1. Press the button.
2. Press the down arrow to highlight the CONFIGURE DEVICE menu, and then press the OK
button.
3. Press the down arrow to highlight the RESET menu, and then press the OK button.
4. Press the down arrow to highlight the RESTORE FACTORY SETTINGS menu, and then press
the OK button.


Post to this thread:

User:
Email:
Notify me if someone responds

Icon:            
Subject:
Message:



© 2012 fixyourownprinter.com, All posts belong to their respective posters