|  Post to this thread Post a new message thread
 | HP Laserjet 1320n Error Lights not in Manual by mephitic (5/27/08 8:18 AM) reply | + / - | I've got a HPLJ 1320n that is showing a combination of status lights which are not in the user's manual (which leads me to believe this isn't going to be good!). The lights I have are:
Toner Light: No Light
Attention Light: Solid Amber/Orange
Ready Light: Blinking Green
Go Button Light: Blinking Green
I've done a power cycle several times leaving the printer off a couple mins each time. Once back on, I can't print a test page or clear the lights. I've changed toners twice and I don't see any paper jams. I'm thinking it's something serious as these lights don't appear in the manual.
Thanks,
MePH
|
 | Re: HP Laserjet 1320n Error Lights not in Manual by mrcjr1234 (5/29/08 9:22 AM) reply | + / - | Did you try upgrading the firmware on the HP website?
Good Luck !
|
| Re: HP Laserjet 1320n Error Lights not in Manual by Sharpie  (5/29/08 11:01 AM) reply | + / - | Well there is no firmware upgrade for this model (unless someone provides a link, I didn't see it on the website).
You can try a cold reset or even an NVRAM reset. (though that'll clear the network settings, & the NVRAM reset will clear serial #, page counts from the configuration page).
Hold down the go button as you power on to do either reset. Let go after 5-15 sec. for a Cold Reset. Hold for more then 20sec. for a NVRAM reset.
It might be the formatter (firmware related too) but there is no firmware DIMM, so replacing the formatter will replace the firmware.
You can try an engine test too, though its a funky model where according the book the formatter has to be connected & you need to remove the left side cover, override the door switch & hit the button (right below the formatter).
|
| Re: HP Laserjet 1320n Error Lights not in Manual by GenRes (6/9/08 6:36 PM) reply | + / - | MePH
Did you find a solution for this problem? I am having the same issue.
Thanks
GenRes
|
 | Re: HP Laserjet 1320n Error Lights not in Manual by nobod (7/24/08 10:35 AM) reply | + / - | I too am having the same problem and have done everything I can find to clear it with no luck.
Does anyone out there have a solution?
|
Post to this thread:
| |