Hi, I have read all the posts I can find here on the Samsung CLP-510, but can't find help anywhere on how to reset the Transfer Belt Life Count. I appreciate any help - thanks!
Re: Samsung CLP-510 Transfer Roller Reset by blaster (3/30/07 10:07 PM) reply
I am also looking for the same procedure. How to reset the transfer belt counter? The CLP-510 hidden maintenance menu lets me reset imaging unit, fuser, transfer roll, MP pickup and tray 1 Pickup. But not the transfer belt counter, which is approaching its page count limit. The printer is working fine and I do not see the need to replace anything. Help please!!
Re: Samsung CLP-510 Transfer Roller Reset by alfonsoveder (3/31/07 12:14 AM) reply
Hi. Forgive me for this dumb question--I am getting two messages. 1) "Replace Imaging Unit Soon" and 2) "Replace Transfer Belt Soon". What is the difference? When I search for each item online, they look the same. What are the ramifications (if any) of trying these resets? Unfortunately, I rely on this printer weekly, so I can't afford to be down, but I'm cheap too!! Thanks!
Re: Samsung CLP-510 Transfer Roller Reset by Anonymous (6/22/07 2:31 PM) reply
OPEN TOP DOOR OF YOUR 510 TRANSFER BELT IS FIRST PART ON TOP WITH GREEN HANDLE MOVE LEVERS ON SIDES AND LIFT IMAGE DRUM IS UNDER THIS BEFOR YOU REMOVE IMAGE DRUM OPEN TONER A PLASTIC PIECE WILL MOVE SOIT WII LIFT RIGHT OUT THE LEDS UNDER THAT IS YOUS LASER ASSAMBLY CARFULY LIFTONE CONER PULL OUT AND BLOW OF WITH CAN AIR ALSO LED DONT USE ANY CLEANERS ON THEESE THEY SEND IMAGE TO DRUM AND PAPER IF YOU KEEP CLEAN YOU SHOULD HAVE GOOD LOOKING PRINTS
Re: Samsung CLP-510 Transfer Roller Reset by Anonymous (2/19/08 11:45 AM) reply
Turn off the unit, hold down enter and turn on. Hit enter when it says EDC mode. Access key is cancel 2x's, menu to maintenance, enter, scroll to imaging unit or transfer roller, enter, when it says initialized turn off and back on.
This is the reset you are looking for.
Re: Samsung CLP-510 Transfer Roller Reset by PIYUSH SHAH (9/27/08 9:19 AM) reply
to reset transferbelt unit u need to flash the eprom on this site u will find info about transfer belt conector a - data b - clock c - ground . on market u can find an simple programer tool with witch u cand rewrite the transfer belt eprom. use e2p from the black catrige.. it;s works - ponyprog for programming
Re: Re: Samsung CLP-510 Transfer Roller Reset by Anonymous (4/15/09 8:06 AM) reply
We followed these instructions, although we found it to be slightly different...we found the access key to be "enter", and hit it 2 times, then scrolled to imaging unit, hit enter, when initialized came up we turned it off and back on. Working fine.
Post to this thread Post a new message thread
