|  Post to this thread Post a new message thread
 | LaserJet 8150n 50.1 fuser error by beetle717 (3/14/06 12:58 PM) reply | + / - | I have an HP Laserjet 8150n model printer that has the error 50.1 fuser error. I have replaced the fuser and the low voltage power supply and am hoping someone here can help me with what the next step needs to be. Thanks to all
|
 | Re: LaserJet 8150n 50.1 fuser error by dmzcompute  (3/14/06 1:51 PM) reply | + / - | The most common issue is the low voltage ps and in fact hp just came out with a service note on it. Are you sure the lvps you put in is ok. If so only two other items could cause the issue. The cable which runs from the lvps to the fuser (to be honest I have never seen a bad one) and the actual voltage at the socket. You need at least 15 amps to run this printer and if the line is a shared line and the voltage should drop, you could get a 50.0 error. Just about every 50.1 error I have seen and I have seen over 100, have been the lvps.
|
| Re: LaserJet 8150n 50.1 fuser error by Stephen (3/14/06 7:12 PM) reply | + / - | If you post the serial number of your printer we can check and see if it is covered by the service note.
|
| Re: LaserJet 8150n 50.1 fuser error by wlulham (3/15/06 6:28 AM) reply | + / - | I've seen the lvps and the fuser go simultaneously a couple times. Did you leave both of the new parts you replaced with in, or did you take one out and replace the other when it didn't work? And as dmz said, are you sure they're good parts?
|
| Re: LaserJet 8150n 50.1 fuser error by Stephen (3/15/06 7:36 AM) reply | + / - | I've only had a handful of LVPS failures, the fuser was good on each of the machines I worked on.
|
Post to this thread:
| |
