|  Post to this thread Post a new message thread
 | Phaser 850 error code 19,002.47 by chromedome5604 (10/20/05 2:26 PM) reply | + / - | Had this error code come up last night. Something about head location calibration?!?! Does anybody have any ideas on solutions to problem for an "at home" fix before I bite the bullet and head for the service shop? Thanks in advance.
|
| Re: Phaser 850 error code 19,002.47 by printertech_us  (10/20/05 2:35 PM) reply | + / - | Error code 19,002.47: The printhead electronics has failed. The electronics include the printhead itself,power control board, power supply or the the data ribbon cable that connects from the power control to the printhead
|
| Re: Phaser 850 error code 19,002.47 by chromedome5604 (10/20/05 3:27 PM) reply | + / - | Thanks. Guess I can start eliminating this one item at a time. The printer was working fine all day, then suddenly stopped putting ink on the sheet. Everything else seemed to be functioning properly. Any guess which one to start with; or should I look for a good used unit to buy!
|
| Re: Phaser 850 error code 19,002.47 by wlulham (10/21/05 1:17 PM) reply | + / - | Eww.
None of those parts are particularly cheap, and it'd be a pain to try and diagnose one of those. Electronics troubleshooting is always a pain in the rear.
The ribbon cable is likely the cheapest to replace. Printhead, Power control board, and power suppply are probably all going to be more then $300 each.
It might be cheaper to just scrap it, honestly. Power supplies and Power control boards seem to have a pretty decent frequency for failure from what I've been hearing. I've only seen one failed power supply so far myself, and I think the power control board is a bit flaky as well.
|
Post to this thread:
| |
