|  Post to this thread Post a new message thread
 | Minolta/QMS 2200 Transfer Belt Reset Fuse by caveman (4/5/05 1:29 PM) reply | + / - | Does anyone know where it is?
|
 | Re: Minolta/QMS 2200 Transfer Belt Reset Fuse by miroljub (4/11/05 12:13 AM) reply | + / - | There is a Fuse on Transfer belt. You can find it on rear side of the cartridge under a plastic cover nearby electric connector, fixed with two screws. Remove this cover, disconnect litle plate (on the plate there is only one part that looks like a resistor - its a fuse). Make short circuit on the fuse or put a wire i connector. Put the transfer belt in the printer, swich on, wait until IDLE apperas. You have to remove a wire from the fuse, and can use your transfer belt like it is NEW.
Good luck!
|
| Re: Minolta/QMS 2200 Transfer Belt Reset Fuse by Anonymous (6/10/08 8:18 AM) reply | + / - | Dear miroljub. You are a genius and a fair man. Just followed your instructions and the green resistor look alike I shorted with two staples which I straightened out and taped to the little circuit board. Machine all happy again and €400 saved.
Thanks
|
| Re: Minolta/QMS 2200 Transfer Belt Reset Fuse by suek (7/24/08 8:12 AM) reply | + / - | Dear miroljub,
Getting the same error message. My printer ran for a long time with this message and then finally stopped. The transfer belt is fairly new. I've shortcircuited the transfer belt, the fuser and the oil roller. None of that is working. Is there an order to this process? Help would be appreciated.
Thanks!
|
 | Re: Minolta/QMS 2200 Transfer Belt Reset Fuse by swales (8/5/08 3:59 AM) reply | + / - | Dear Miroljub
Your instructions have also worked for my aculaser c2000: I had nearly given up finding a way to reset it.
Thanks!
|
| Re: Re: Minolta/QMS 2200 Transfer Belt Reset Fuse by Anonymous (8/29/08 11:57 AM) reply | + / - | Nice to find someone that knows these machines. I have rebuilt toner cartridges as a business and the 2200 stumps me when it comes to things like the Transfer Belt. My machine has a lot of copies but not over 100,000. My next question is how do we clean the Transfer Belt so it works like new.
Many thanks in advance
please email me at txjoel1@gmail.com
JInTx
|
Post to this thread:
| |