|  Post to this thread Post a new message thread
 | Laserjet 4si Jamming by John (11/26/04 7:47 AM) reply | + / - | I have a Laserjet 4si that jams on every page. The paper stops about 1 - 2 inches out of the fuser. The paper is fine, and does not accordian.
|
 | Re: Laserjet 4si Jamming by dmzcompute  (11/26/04 8:43 AM) reply | + / - | Does it happen with 1 page job or only with mulitple page jobs and is it stopping in the same place with the 1 page job. One thing you can do to try to narrow down what is happening is to change the output on the menu to the face up tray in the back which you have to open. After you make the menu change you will have to turn off the prnter and turn it back on for it to take effect. If the paper still jams I would lean towards a fuser issue if it happens on single sheet jobs. If all the jobs are mulitple you will have to make sure it is not a pickup issue or selenoid issue since the jam causing the printer to stop could be anywhere along the paper path. If it feeds ok to the faceup tray, your issue is then the diverter or the exit assembly in the upper cover. I would also check for broken plastic guides or something preventing the paper from entering the upper cover exit path.
|
| Re: Laserjet 4si Jamming by John (11/26/04 8:47 AM) reply | + / - | It happens on all print jobs, no matter what the size. I removed the fuser, and while examining it, what I believe to be the exit flag, one of the mounting tabs for it is broke off and the flag is dangling there.
|
 | Re: Laserjet 4si Jamming by moe (11/26/04 10:04 AM) reply | + / - | The exit flag starts in the center and the flag portion of it is at the top right of the fuser. Is the flag itself broken or the part that it mounts to?
|
| Re: Laserjet 4si Jamming by John (11/29/04 12:37 PM) reply | + / - | The part that it mounts to is broken. One of the clips is broke off.
|
Post to this thread:
| |
