|  Post to this thread Post a new message thread
 | HP PSC 2110 Plastic Strip by Ron Lloyd (4/14/05 1:49 PM) reply | + / - | A customer brought in a PSC 2110 that their kid has stuck his hand into. There is a small transparent strip of plastic that is still attached at the right side of the printer (from the front) but I can't seem to figure out where it attachs to on the carriage. Any help or pictures :-) would be appreciated.
|
| Re: HP PSC 2110 Plastic Strip by Bert  (4/14/05 4:08 PM) reply | + / - | The encoder strip does not attach to the carriage. It passes through a slot in the carriage and attaches to a springy hook on the left and stationary hook on the right.
|
 | Re: HP PSC 2110 Plastic Strip by moe (4/14/05 4:53 PM) reply | +1 + / - | I've seen that happen more times than I can remember. Kids just love to stick their little hands in and see what they can yank out. The one end probably tore. You can mend it by wrapping it with some clear scotch tape. Then cut a hole in it with a razor, approximating the original hole. Hang it back on the hook and tell them to keep it covered or out of reach.
|
 | Re: HP PSC 2110 Plastic Strip by Rex11 (1/25/06 11:08 PM) reply | + / - | My cat got a little too excited while I was printing and lunged into the mouth of the printer and yanked out the plastic strip. Thankfully it is still in tact.
First, what is the purpose of this strip?
Second, how do I put it back properly? Thanks!
|
Post to this thread:
| |
